give two examples of contact force and non contact force

Answer:

h = 4.25 m

Explanation:

[tex]gravitational \space\ potential \space\ energy \space\ (gpe)= m g h\\[/tex] ,

where m is the mass, g is acceleration of gravity, and h is height of object.

In our case, m = 1.2 kg, g = 9.8m/s², and gpe = 50 J.

50 = 1.2 x 9.8 x h

h = 50 / (1.2 x 9.8)

h = 4.25 m

Answer:

4.25m

Explanation:

Joules is a "derived unit", meaning it is really composed of other units, and it is just abbreviated as a single letter.

[tex]1[J]=1 [\frac{kg \cdot m^2}{s^2}][/tex]

This comes from the formula for potential energy, often denoted "U"

[tex]U=mgh[/tex], where m is the mass of the object (measured in kilograms,  [tex]kg[/tex]), g is the acceleration due to gravity at that spot (measured in meters per second squared,  [tex]\frac {m}{s^2}[/tex]), and h is the height of the object (measured in meters, [tex]m[/tex]).

Note:  The object itself may or may not have an acceleration of "g" at the given point because it may be supported (like on a bookshelf).  However, the "g" is representative of its gravitational acceleration at that point if gravity could accelerate it unimpeded.

Rearranging the potential energy equation to isolate the unknown "h", dividing both sides by "m" and "g", we get the following:

[tex]\dfrac{U}{mg}=h[/tex]

Substituting known values (and rewriting Joules as its SI units so we can ensure units cancel the way we need them to):

[tex]\dfrac{\left (50 [\frac{kg \cdot m^2}{s^2}] \right)}{(1.2 [kg])(9.8 [\frac{m}{s^2}])}=h\\\dfrac{\left (50 [\frac{kg \!\!\!\!\!\!\!{--} \cdot m^{2 \!\!\!{-}}}{s^2\!\!\!\!\!\!\!{--} }] \right)}{(1.2 [kg \!\!\!\!\!\!\!{--} ])(9.8 [\frac{m\!\!\!\!\!\!\!{--} }{s^2\!\!\!\!\!\!\!{--} }])}=h\\\dfrac{(50)}{(1.2)(9.8)}[m]=h\\\\4.2517[m] \approx h[/tex]

Thus, the height of the book would be approximately 4.25meters high.

To find how far away the school is:

3m/s * 30 s = 90m

Hope it helps!

The statement that is true about solar system densities is The denser planets lie closer to the Sun while the farther one planets from the sun have lower densities.

Solar system comprises of the the planets, moon, stars, comets , smaller bodies and how they orbit around the sun.

Therefore, The statement that is true about solar system densities is The denser planets lie closer to the Sun.

Learn more about solar system below.

https://brainly.com/question/23169135

#SPJ11

Answer:

No

Explanation:

The fastest recorded time for a person to run 100 metres is 9.58 seconds, which is the equivalent of 10.4 metres per second

Answer:

No

Explanation:

Humans can run as fast as 19.3m/s, using their full possible energy.

Answer:

All move at the same speed

Explanation:

because they are all waves of the electromagnetic spectrum and they all travel at the speed of light

(300 000 km/s)

Answer:

75%

Explanation:

Efficiency=MA/VR*100

=3/4*100

=0.75*100

=75%

To get zero as a resultant of vector A, we need to add another vector that has the same magnitude and different direction to vector A.

Vectors are those quantities that has both magnitude and direction.

The result or resultant of two vectors is the single value obtained when two vectors are combined.

For a vector to have a resultant of zero, the vector need to be added to another vector of the same magnitude and different direction.

From the above,

To get zero as a resultant of vector A, we need to add another vector that has the same magnitude and different direction to vector A.

Learn more about vectors here: https://brainly.com/question/25705666

#SPJ12

The difference in time between the sound waves being detected at the other end of the plank and the sound being heard through the air will be 0.09 sec.

A sound wave is produced when a medium begins to vibrate. When an entity vibrates, a pressure wave is formed, which causes sound.

Given data;

The speed of sound in wood,u= 3300 m/s

The speed of sound in air,v=330 m/sec

long plank of wood, L=33 m

The time period in the air was found as;

T₁ = 33 m / 330 m/sec

T₁= 0.1 sec

The time period in wood ;

T₂= 33 m / 3300 m/sec

T₂=0.01 sec

T = T₁ - T₂

T=0.1-0.01

T=0.09 sec

Hence, the difference in time between the sound waves being detected at the other end of the plank and the sound being heard through the air will be 0.09 sec.

To learn more about the sound wave, refer to https://brainly.com/question/11797560.

#SPJ1

The total cost for the energy used if electricity costs 10p per unit is determined as 2p.

The total energy consumed during the process is calculated as follows;

E = Pt

where;

E = (800 W/1000) x (2.5 /60)   + (2 kW) x (5/60)

E = 0.8 kW x 0.042 hr     +    2kW x 0.083 hr

E = 0.0336 kW-hr  +  0.166 kW-hr

E = 0.1996 kW-hr

C = E x 10p

C = 0.1996 kW-hr x 10p

C = 1.996p

C ≈ 2p

Thus, the total cost for the energy used if electricity costs 10p per unit is determined as 2p.

Learn more about cost energy here: https://brainly.com/question/3303657

#SPJ1

Answer:

440J

Explanation:

First, let us find the weight of the barbell.

The formula to find the weight is :

W = m × g

Here,

m ⇒ mass ⇒ 20 kg

g ⇒ acceleration of gravity

Let us find it now.

W = m × g

W = 20 kg × 10 ms⁻²

W = 200N

And now let us find the work done by this weight lifter.

Work = Force × Displacement

Let us find it now.

Work = Force × Displacement

         = 200N × 2.2m

         = 440J

Total units

Cost°

Answer:

A downward force of magnitude 5 N is exerted on the book by the force of ... Do the downward force in Part A (gravity) and the upward force in Part B ...

Answer:

the weight of displaced liquid is equal to the submerged part of ship. so on adding more weight to ship net buyoncy acting on ship increases and more the ship sinks in sea thus weight of displaced liquid increases.

Explanation:

Answer:

Higher mass or higher speed

Explanation:

Higher mass will require more force

F= ma       if m goes up  F   goes up   to stop in the same distance

Answer:

Titan.It is the largest moon of Saturn

The area would be 13.1429 Meter².

Answer:

[tex]\boxed {Area = 13.14 m^{2}}[/tex]

Explanation:

Formula applied :

[tex]\boxed {Area = \frac{Pressure}{Force}}[/tex]

Given :

Solving :

Answer:

Periodic

Explanation:

The groups in the periodic table that want to gain electrons are groups; 15, 16 and 17. The members of these groups are mostly nonmetals.

Answer:

I think it would be C: open primary

Explanation:

All move at the same speed.

Explanation:

Electronic magnetic spectrum includes radio waves, micro waves, infra red, visible light, ultra violet, x-rays, gamma rays. These all electromagnetic waves travel at the same speed of light of about 300,000,000 m/s through vacuum. Though they have different wavelength, their speed is same.

Answer:

D

Explanation:

Deep sea and sea floor marine habitats would have the least access to primary producers. The correct option is (d).

Primary producers would have the least access to habitats in the deep sea and on the ocean floor. Primary producers are animals and plants that can use sunlight as an energy source to photosynthesize and make their own food, including algae and phytoplankton.

Because of the depth of the water, light penetration is constrained in the deep sea and sea floor settings, making it difficult for creatures that rely on photosynthesis to survive.

In comparison to other maritime ecosystems, where sunlight is more easily obtainable, such as coral reefs, lagoons, salt marshes, estuaries, mangroves, and intertidal zones, these habitats often have lower amounts of primary production.

Therefore, The correct option is (d) deep sea and sea floor.

To know more about the primary producers:

https://brainly.com/question/32998549

#SPJ3

Answer:

No

Explanation:

In order for the rope to be perfectly horizontal, there must be a vertical component in tension

Answer:

The amount of thermal energy needed is 626.6 J

Explanation:

When a certain amount of heat energy Q is supplied to a substance, the temperature of the substance increases according to the equation

where m is the mass of the substance is the specific heat capacity of the substance is the change in temperature

Answer:

642.6 kJ

Explanation:

Using the formula for heat energy required:

[tex]Q = mc \Delta T[/tex] ,

where:

C   → specific heat capacity  =  1.68 kJ/kg°C

Q   → heat energy required  =  ?

m   → mass of the object  =  4.5 kg

ΔT → change in temperature  =  97°C - 12°C  =  85°C,

Q = 4.5  x  1.68  x  85

   = 642.6 kJ

The speed the golf must have initially to reach the hole is 31.32`1 m/s.

When an object is thrown at an angle from the horizontal direction, the object is said to be in projectile motion. The object which follows the projectile motion.

A golfer wishes to chip a shot into the hole 50m away on flat level ground. if the ball flies to a maximum height of 25m.

The angle with which the ball flies,

tan θ = 25 m/ (50m/2)

tan θ =1

θ  =45°

If u is the initial speed, the maximum height of the ball is

H = u² sin²θ / 2g

Put the values, we get

25 =  u² sin²45 / (2x9.81)

u = 31.321 m/s

Thus, the initial speed is 31.321 m/s

Learn more about projectile.

brainly.com/question/11422992

#SPJ1

Answer:

10^2 + 10^2 = x^2

x = 14.2 m NW

Answer:

C.

Explanation:

Specific heat capacity is defined as the amount of heat energy needed to increase the temperature of 1kg of a substance by 1°C.

The formula for specific heat capacity is as follows:

[tex]C = \frac{Q}{m \Delta T}[/tex]

where:
C   → specific heat capacity

Q   → heat energy required

m   → mass of the object

ΔT → change in temperature.

From the calculations, the force required is 0.437 N.

The term force is defined a the product of mass and acceleration. The force is required to move the sling the required distance.

If mass = 0.019 kg and acceleration =  23 m/s2 then we know that F = ma

It then follows that the required force is;

F = 0.019 kg  *  23 m/s2= 0.437 N

Missing parts

You plan to use a slingshot to launch a ball that has a mass of 0.019 kg. You want the ball to accelerate straight toward your target at 23 m/s2. How much force do you need to apply to the ball?

Learn more about force:https://brainly.com/question/13191643

#SPJ1

Glenohumeral external rotation is the concurrent motion at the glenohumeral joint which occurs with shoulder abduction.

This refers to the process in which the arm is moved away from the body which also affects the ball and socket joint.

This is referred to as glenohumeral joint in this case which moves in an external rotation manner.

Read more about Shoulder abduction here https://brainly.com/question/9229072

#SPJ12

Explanation:

1. the potential difference across the combination is the algebraic sum of yhe potential differences across the individual capacitors

2. the equivent capacitance of the combination is less than the capacitance of any of the capacitors..

At any crime scene, the two greatest challenges to the physical evidence are contamination and loss of continuity.

In evidence law, physical evidence (also called real evidence or material evidence) is any material object that plays some role in the matter that gave rise to the litigation, introduced as evidence in a judicial proceeding (such as a trial) to prove a fact in issue based on the object's physical characteristics.

The two types of evidence at crime scenes:

Biological evidence (e.g., blood, body fluids, hair and other tissues)

Latent print evidence (e.g., fingerprints, palm prints, footprints)

The biggest impediment to an investigation is the removal or loss of a piece of evidence from the scene of a crime.

Hence, at any crime scene, the two greatest challenges to the physical evidence are contamination and loss of continuity.

Learn more about the physical evidence here:

https://brainly.com/question/13505766

#SPJ1

Answer:

0 m/s²

Explanation:

Acceleration is defined as the rate of change of velocity:

[tex]acceleration = \frac{change \space\ in \space\ velocity}{time taken}[/tex] .

As the velocity is constant, change in velocity = 0.

∴ acceleration = 0/ 10

                        = 0 m/s²